The Coffee Kits

Step-by-Step Guide on How to Fold a Chemex Filter

Chemex coffee makers are known for their iconic design and ability to produce a clean, smooth cup of coffee. To achieve this, a Chemex filter is an essential component. But, without proper folding and preparation, the filter can be a source of frustration for coffee lovers. In this article, we will provide a step-by-step guide on how to fold a Chemex filter to ensure a perfect cup of coffee every time.

Step 1: Preparing the Filter

The first step in folding a Chemex filter is preparing it. Begin by unfolding the filter and placing it into the Chemex with the three-layered side facing the spout. Next, pour hot water over the filter to rinse out any paper taste and warm the Chemex. Discard the water and proceed to fold the filter.

Step 2: First Fold

Take the side of the filter with the three layers and fold it towards the spout, creating a cone shape. Ensure that the pointed end of the cone is at the spout. The folded edge should rest against the opposite side of the filter.

Step 3: Second Fold

Next, fold the filter in half by bringing the opposite side of the filter towards the spout, aligning with the previous fold. This should create a V shape. Ensure that the tip of the V is at the spout, and the two sides of the filter are even.

Step 4: Third Fold

Now, fold each side of the filter towards the center, creating two more V shapes. Ensure that the tips of the V's meet at the spout. The filter should now resemble a three-pointed star.

Step 5: Final Fold

Take one of the V-shaped flaps and fold it over the other, creating a cone shape. The filter should now resemble a truncated cone, with a pointed end at the spout and a flat end at the top.

Step 6: Adding Coffee

After folding the filter, add coffee grounds to the top of the filter. Use a scale to measure the appropriate amount of coffee based on the desired strength and flavor profile.

Step 7: Pouring Water

Finally, it's time to pour the water. Begin by pouring a small amount of water over the coffee grounds, known as the bloom. Allow the coffee to bloom for 30 seconds before slowly pouring the remaining water over the grounds. The entire process should take approximately 3-4 minutes.

Conclusion

By following these seven simple steps, you can fold a Chemex filter with ease and achieve a perfect cup of coffee every time. Remember to rinse the filter before folding, and measure the appropriate amount of coffee and water for the desired strength and flavor profile. With a little practice, you'll be a Chemex expert in no time.